DIY Blacksmith Shop Tricks

So I have a gas saver for my cutting torch, and I use it often. I don't like having a cart with my tanks on them so I have enough hose to reach anywhere in the shop. I did not want to have a cart ot stand for the gas saver either. So I needed a solution to allow me to used that tool were I need to. So here is my solution.

I built a pad with a stinger welded to it just like one you would slide into your pick up to tow a trailer.

Then I made several receivers.

I welded them on both ends of my welding table as well as my vises.

So here is the gas save in the receiver on one end of my welding table.